|Session Title||Moving from self-built MDSD tools towards a standard tool chain
|Session Type||Case Study
Ever had the same experience? We wanted to do some Model Driven Software Development but the available tools did not fit our requirements or were too expensive or too complicated, or, or, or... So we started our own MDSD tools, which evolved and grew, and grew, and now? At some point we realized that maintaining our own MDSD tools was very expensive so we thought about switching (back) to an adaptable Standard MDSD Toolchain.
This Case Study is based on a real world project, where we developed devices with MDSD tools.(self-built and with a standard tool chain). Bernhard discusses the pros and cons of both approaches and also shows how they migrate(d) from self-built MDSD towards a standard tool chain.
|Speaker(s)||Bernhard Merkle (SICK AG)
Bernhard Merkle works as a Software Architect and Engineer for Software Engineering in the central Research & Development Department at SICK AG, one of the worlds leading producers of sensors and sensor solutions. He serves as internal consultant for the complete Software Development Cycle and is responsible for Process and Methods selection as well as Tool evaluation and Introduction. In his spare time he gives a lecture about MDSD (Model Driven Software Development)at the University of Furtwangen in the Faculty Application Architecture Master.
|Intended Audience||Beginners and upwards.|